Skip to content
Shiloh Drywall Repair
(618) 800-2556Call 7 days, 7am–9pm
Ask for an estimate

Holes and dents

Drywall Hole Repair in Shiloh, IL

Drywall hole repair in Shiloh covers anything from a doorknob strike to a cut-out left after a plumber worked inside the wall. Anything small gets filled; bigger damage gets backing, new drywall and a full set of taped coats, so the sheetrock repair is flat and does not crack along its outline later.

1. Hole size sets the method

Fill

Under 1 inch

Anchor holes, screw holes and small punctures. Cleaned out, filled with setting compound and finished flat with two light coats.

Patch

1 to 6 inches

Doorknob holes and small impacts. A patch with a paper or mesh face, or a small piece of board on a clip, then taped and coated.

Replace

Over 6 inches

Impact holes, cut-outs and broken board. The opening is trimmed to a rectangle reaching the closest studs or backed with wood strips, and new drywall is fastened in and taped on all four sides.

2. What a patch needs so it stays invisible

The difference between a patch that disappears and one that shows is mostly in the prep. The torn paper around the hole is cut away, because loose paper bubbles under compound. The hole is squared up so the new piece fits with a narrow, even gap. Backing goes behind any piece larger than a few inches so the patch cannot flex when the wall is touched.

The first coat bonds the tape. Later coats reach farther out so the patch tapers into the wall instead of forming a raised square. The finished surface is sanded, given the same texture as the rest of the wall and primed. Primer matters: bare compound absorbs paint differently from painted drywall, and skipping it leaves a dull square.

3. Typical ranges

Fixr's national guide puts the repair of holes in drywall at roughly $60 to $200, with general drywall repair at roughly $200 to $550. Hole size, whether backing is needed, texture, height and the number of holes in the same visit drive the price. The local contractor sets the actual figure after seeing the wall.

4. Where holes turn up in local houses

Most holes in Shiloh houses are in the same places: behind bedroom and bathroom doors, along hallways where furniture is carried, in garages where the wall shared with the house takes hits, and in walls opened for plumbing or wiring. A garage wall shared with the house is often built as a fire-resistant wall, and repairs there use the same fire-resistant type of board.

Shiloh went from 2,655 residents in 1990 to 14,098 in 2020, and most of its homes, on both sides of Greenmount Road, have textured drywall from that period. A hole repair there is mostly about getting the texture right. In winter, when average lows sit below freezing from December through February, keep the room heated so the compound sets up between coats.

5. Hole repair questions

Can a hole behind a door be patched without replacing the whole sheet?

Yes. A square section around the hole is replaced and finished. Installing a door stop afterward keeps it from happening again.

What happens to a cut-out the plumber left?

Once the plumbing work is finished and dry, the opening is squared up, backed and closed with new board, then taped, textured and primed.

Does texture make a hole repair harder?

It adds a step. Smooth walls show every flaw, and textured walls have to match a pattern. Both are workable.

Will the patch crack around its edges later?

A patch that is backed and taped on every side should not. Cracks around a patch usually come from an unbacked piece flexing or from compound used without tape.

6. Close up the hole

A drywall contractor who works around Shiloh looks at the wall and prices it with you before anything is cut.

Call 7 days, 7am–9pm

CallSend a snapshot